Avaya 5000 Series Installation Manual page 78

Procedures for installation of the switch
Label
LNK/ACT
Table 13: Shared SFP transceiver Port LED state indicators
Label
In Use
LNK/ACT
Table 14: XFP transceiver port LED state indicators
LED Color / Status
Tx Green / steady
Rx Green / steady
Tx Green / blinking
Rx Green / blinking
Tx Amber / steady
Rx Amber / steady
Tx Amber / blinking
Rx Amber / blinking
Both Off
The Amber LEDs are usually only used during the boot process. Under normal operation,
Green is the only color the XFP LED should emit.
78 Avaya Ethernet Routing Switch 5000 Series Installation
Color / Status
Amber / steady PoE DTE short or the power allocated to this port has
been exceeded.
Amber / blinking Power budget exceeded.
Green / steady Link established but no data activity.
Green / blinking There is activity on this port. The blinking rate indicates
the level of activity.
Off No link.
Color / Status
Green / steady The port has a link established.
Off The port does not have a link established.
Green / steady This link is operating normally.
Green / blinking There is activity on the port.
Green / slow blinking The port has been disabled by the software.
Off Indicates that the link has been lost.
Link established.
Transmit activity detected.
Receive activity detected.
Transmit activity enabled.
Fiber connected with signal present.
XFP has been installed. Laser Transmitter OFF or XFP in Reset.
XFP has been installed. No Signal Detected or XFP in Reset.
No XFP installed.
Description
Description
Description
December 2010