Avaya 5000 Series Installation Manual page 84

Procedures for installation of the switch
3. Press the UI button and hold it in for 3 seconds to confirm the command.
Assigning IP parameters using Enterprise Device Manager
The following procedure describes how to use Quick Start to assign IP parameters to the ERS
5000 Series switch.
1. Connect a computer to the switch through a data port using a standard RJ-45
2. Open a web browser on the attached computer.
3. Enter the factory default IP address of the switch in the following format: http://
4. From the navigation tree, click Administration > Quick Start.
5. In the In-Band Stack IP Address dialog box, type a switch or stack IP address .
6. In the In-Band Subnet Mask dialog box, type a subnet mask.
7. In the Default Gateway dialog box, type an IP address.
8. Click Apply.
84 Avaya Ethernet Routing Switch 5000 Series Installation
The Base LED and the Up and Down LEDs are now steady amber to indicate that
the button press was recognized.
The In-Use IP address changes to the IP address of your switch.
The color and status of the Status LED turns to steady green when the system
accepts the command. If the system rejects the command, the Status LED turns to
amber blinking.
Initial IP configuration using the UI/Mode Select button is complete.
To continue switch configuration, access the switch through the ACLI or Enterprise
Device Manager.
network cable.
<IPAddress>.
The main screen of the Enterprise Device Manager Interface opens.
The IP/Community/Vlan work area opens.
Note:
For further switch configuration information, see Avaya Ethernet Routing Switch
5000 Series Configuration-System (NN47200–500).
December 2010