Huawei UPS2000-G-1KRTS User Manual page 28

UPS2000-G-(1 kVA-3 kVA)
User Manual (2016, Russia)
Figure 4-3 Setting parameters on the LCD
When the UPS is in standby mode or bypass mode, hold down SELECT for 5 seconds to start
setting UPS parameters.
When the UPS is in normal mode or battery mode, hold down SELECT for 5 seconds to start
setting only for 11 UPS buzzer parameters.
During the setting of UPS parameters, press ON/MUTE for more than 3 seconds. Release the
button when you hear a beep sound to select the previous option. During the setting of UPS
parameters, press SELECT for more than 3 seconds. Release the button when you hear a
beep sound to select the next option. Press OFF/ENTER for more than 3 seconds to confirm
the setting.
The following figures show the twelve parameter setting screens.

Display

Issue 02 (2016-07-28)
01: Set the output voltage.
02: Enable or disable the frequency conversion mode.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Setting Control Panel
Setting
The output voltage can be set as follows:
200: The output voltage is 200 V AC.
208: The output voltage is 208 V AC.
220: The output voltage is 220 V AC.
230: The output voltage is 230 V AC
(default value).
240: The output voltage is 240 V AC.
22