Mitsubishi ASX 2016 Owner's Manual page 48

Keyless operation system*
NOTE
l If your remote control switch is lost or dam-
aged, please contact your MITSUBISHI
3
MOTORS Authorized Service Point for a re-
placement remote control switch.
l If you wish to add a remote control switch,
please contact your
MOTORS Authorized Service Point. A max-
imum of 4 remote control switches are avail-
able for your vehicle.
Setting of door and tailgate un-
lock function (Except for vehi-
cles equipped with a Dead Lock
System)
The door and tailgate unlock function can be
set to the following two conditions.
Each time the door and tailgate unlock func-
tion is set, a chime will sound to tell you the
condition of the door and tailgate unlock
function.
Number of
chimes
All doors and the tailgate un-
One chime
lock
Two chimes Driver's door unlock only
1. Put the operation mode in OFF.
3-24 Locking and unlocking
2. Place the combination headlamps and
dipper switch in the "OFF" position, and
leave the driver's door open.
3. Press and hold the LOCK switch (1) for
4 to 10 seconds and then also press the
UNLOCK switch (2) during this time.
4. Release in sequence the LOCK and UN-
MITSUBISHI
LOCK switches within 10 seconds of
pressing the LOCK switch in step 3.
Procedure for replacing the re-
mote control switch battery
1. Before replacing the battery, remove
static electricity from your body by
touching a metal part such as doorknob
of the room.
E00310400304
WARNING
l Danger of explosion if battery is incor-
rectly replaced.
Replace only with the same battery or an
equivalent type.
Condition
CAUTION
l When the remote control switch case is
opened, be careful to keep water, dust, etc.
out. Also, do not touch the internal compo-
nents.
E00309601114
OGAE15E5
NOTE
l You may purchase a replacement battery at
an electric appliance store.
l A MITSUBISHI MOTORS Authorized
Service Point can replace the battery for you
if you prefer.
2. With the MITSUBISHI mark facing
you, insert the cloth covered tip of a
straight blade (or minus) screwdriver in-
to the notch in the remote control switch
case and use it to open the case.
NOTE
l Be sure to perform the procedure with the
MITSUBISHI mark facing you. If the
MITSUBISHI mark is not facing you when
you open the remote control switch case, the
transmitter may come out.
3. Remove the old battery.