Mitsubishi ASX 2016 Owner's Manual page 338

Table of Contents

Advertisement

Tyre repair kit*
NOTE
l
Simply putting sealant and air into the tyre
using the tyre repair kit does not seal the
puncture hole. Air will leak through the
puncture hole until the emergency repair
procedure is completed (through step 19 of
these instructions).
17. Affix the speed restriction sticker (Q) to
the steering wheel at the position shown
in the illustration. Then immediately
drive with great care to a MITSUBISHI
8
MOTORS Authorized Service Point or
another specialist and have tyre repair/
replacement performed.
8-12
For emergencies
CAUTION
l
Do not affix the sticker anywhere except the
specified position on the pad of the steering
wheel. Affixing the sticker in an incorrect
position could prevent the SRS airbag from
working normally.
l
Be sure to check the tyre pressure for confir-
mation that the emergency repair procedure
is complete.
18. When you have inflated the tyre to the
specified pressure, stow the compressor,
bottle, and other items in the vehicle and
promptly start driving the vehicle so that
the tyre sealant can spread evenly in the
tyre. Drive with great care. Do not ex-
ceed a speed of 80 km/h (50 mph). Ob-
serve local speed limits.
CAUTION
l
If you sense any abnormality while driving,
stop the vehicle and contact a MITSUBISHI
MOTORS Authorized Service Point or an-
other specialist. Otherwise the tyre pressure
may drop before the emergency repair pro-
cedure is completed, rendering the vehicle
unsafe.
NOTE
l
Driving faster than 80 km/h (50 mph) can
make the vehicle vibrate.
OGAE15E5
19. After driving for 10 minutes or 5 km
(3 miles), check the tyre pressure using
the air pressure gauge on the compres-
sor.
If the tyre pressure is not sufficient, in-
flate the tyre to the specified pressure
again and drive the vehicle carefully
without exceeding a speed of 80 km/h
(50 mph).
CAUTION
l
If the tyre pressure is lower than the mini-
mum
permitted
pressure
{130 kPa}), the tyre cannot successfully be
repaired with the tyre sealant. Do not drive
the
vehicle
any
further.
MITSUBISHI MOTORS Authorized Serv-
ice Point or another specialist.
20. After driving for 10 minutes or 5 km
(3 miles), check the tyre pressure using
the air pressure gauge on the compres-
sor. If the tyre pressure has apparently
not dropped, the emergency repair pro-
cedure is complete. You must still not
exceed a speed of 80 km/h (50 mph).
Observe local speed limits.
(1.3
bar
Contact
a

Advertisement

Table of Contents
loading

Table of Contents