Turbocharger Operation - Mitsubishi ASX 2016 Owner's Manual

Turbocharger operation*

l With the bar graph of engine coolant
temperature display stabilized in roughly
the middle of the scale, drive for about
20 minutes at a speed of at least 40 km/h
(25 mph).
[Diesel-powered 1600 models]
l
As soon as traffic conditions allow, re-
generate the filter by driving at a speed
6
of over 60 km/h (37 mph) until the
warning display goes out.
If the DPF warning display subsequently
stays on, contact a MITSUBISHI MOTORS
Authorized Service Point.
CAUTION
l You do not have to continuously drive ex-
actly as indicated above. Always strive to
drive safely in accordance with road condi-
tions.
6-18 Starting and driving
If the DPF warning display and
check engine warning lamp il-
luminate at the same time dur-
ing vehicle operation
Warning lamp
Warning display type 1
Warning display type 2
If an abnormal condition occurs in the DPF
system, the DPF warning display and check
engine warning lamp illuminate. Have the
system inspected by a
MOTORS Authorized Service Point.
OGAE15E5
CAUTION
l Continuing to drive with the DPF warning
display and check engine warning lamp illu-
minating could result in engine trouble and
DPF damage.
Turbocharger operation*
CAUTION
l Do not run the engine at high speeds (for ex-
ample, by revving it or by accelerating rap-
idly) immediately after starting it.
l Do not stop the engine immediately after
high-speed or uphill driving. First allow the
engine to idle to give the turbocharger a
chance to cool down.
MITSUBISHI
E00611200083