Mitsubishi ASX 2016 Owner's Manual page 157

NOTE
• Turn the combination headlamps and dip-
per switch to the " " or "
• Turn the ignition switch to the "ON" posi-
tion or put the operation mode in ON.
l It is possible to modify functions as follows:
• The headlamps can be set to come on in
the low beam setting.
The welcome light function can be deacti-
•
vated.
For further information, please contact your
MITSUBISHI MOTORS Authorized Serv-
ice Point.
Coming home light
This function turns on the headlamps in the
low beam setting for about 30 seconds after
the ignition switch is turned to the "OFF" po-
sition or the operation mode is put in OFF.
1. Turn the combination headlamps and
dipper switch to the "OFF" or "AUTO"
position (for vehicles equipped with the
automatic lamp control).
2. Turn the ignition switch to the "LOCK"
position or put the operation mode in
OFF. Also, if a key was used to start the
engine, remove the key from the ignition
switch.
3. Within 60 seconds of turning the igni-
tion switch to the "OFF" position or put-
ting the operation mode in OFF, pull the
turn signal lever towards you.
" position.
E00529000526
Combination headlamps and dipper switch
4. The headlamps will come on in the low-
l
l
OGAE15E5
beam setting for about 30 seconds. After
the headlamps go off, the headlamps can
be turned on again in the low beam set-
ting for about 30 seconds by pulling the
turn signal lever towards you within 60
seconds of turning the ignition switch to
the "OFF" position or putting the opera-
tion mode in OFF.
To turn on the headlamps again after 60
seconds of turning the ignition switch to
the "OFF" position or putting the opera-
tion mode in OFF, repeat the process
from step 1.
NOTE
While the coming home light function is op-
erating, perform one of the following opera-
tions to cancel the function.
• Pull the lever towards you.
• Turn the combination headlamps and dip-
per switch to the " " or " " position.
• Turn the ignition switch to the "ON" posi-
tion or put the operation mode in ON.
It is possible to modify functions as follows:
• The time that the headlamps remain on
can be changed.
The coming home light function can be
•
deactivated.
For further information, please contact your
MITSUBISHI MOTORS Authorized Serv-
ice Point.
Instruments and controls
5
5-53