Mitsubishi ASX 2016 Owner's Manual page 334

Table of Contents

Advertisement

Tyre repair kit*
4- Valve remover
5- Filler hose
6- Speed restriction sticker
How to use the tyre repair kit
CAUTION
l
The tyre sealant can cause health damage if
swallowed. If you accidentally swallow it,
drink as much water as possible and imme-
diately consult a doctor.
l
If the tyre sealant gets in your eyes or on
your skin, rinse with lots of water. If you
8
still sense an abnormality, consult a doctor.
l
Consult a doctor immediately if any allergic
reactions occur.
l
Do not allow children to touch the tyre seal-
ant.
l
Do not breathe in the vapours of tyre sealant.
NOTE
l
The tyre sealant cannot be used in any of the
situations listed below. If any of these situa-
tions occurs, please contact a MITSUBISHI
MOTORS Authorized Service Point or an-
other specialist.
The tyre sealant's expiry date has passed.
(The expiry date is shown on the bottle la-
bel.)
8-08
For emergencies
NOTE
More than one tyre is punctured.
The puncture hole has a length or width of
4 mm or more.
The tyre is punctured in the side wall (A),
not in the tread (B).
The vehicle has been driven with the tyre
almost completely flat.
OGAE15E5
NOTE
The tyre has completely slipped over the
wheel rim and has come off the wheel.
The wheel is damaged.
l
Use the tyre sealant only at ambient temper-
atures of -30 °C to + 60 °C.
l
Effect an emergency repair without pulling
out the object (nail, screw, etc.) that is stuck
in the tyre.
l
Do not use the tyre sealant if the tyre has
been damaged by being driven when insuffi-
ciently inflated (e.g. bumps, cuts, cracks etc.
on the tyre).
l
Wipe tyre sealant off the paintwork immedi-
ately with a damp cloth.
l
Immediately wash clothes contaminated
with tyre sealant.
Before repairing a tyre, first stop your vehicle
in a safe, flat location.
1. Park the vehicle on level and stable
ground.
2. Set the parking brake firmly.
3. On vehicles with M/T, stop the engine
and move the gearshift lever to the "R"
(Reverse) position.
On vehicles with A/T or CVT, move the
selector lever to the "P" (PARK) posi-
tion and stop the engine.

Advertisement

Table of Contents
loading

Table of Contents