Deactivation Of The Machine; Maintenance - Fimap Maxima Base E Use And Maintenance Manual

DEACTIVATION OF THE MACHINE

WARNING:
• Always protect the machine against sunlight, rain, and other atmospheric agents, both while
it is stationary and while it is functioning. Store the machine in a dry, sheltered place: this
machine is only designed for use under dry conditions, and must not be used or stored
outdoors in humid conditions.
• Do not park the machine near combustible materials, powders, gases or liquids.
• Stop the machine on a flat surface.
• Switch off the machine using the main switch (then removing the key from the block) and
remove the plug of the power cable from the wall socket.
• If the machine is left unattended, it must be protected from any accidental movements
ATTENTION:
• The machine must only be stored under temperature conditions ranging from 0 °C to +40 °C.
The humidity level must be between 30% and 95%.

MAINTENANCE

DANGER:
• To avoid short-circuits when working in the vicinity of electrical components: avoid the use of
non-insulated tools; do not place or allow metallic objects to fall upon the electrically powered
components; remove rings, watches and/or clothing with metallic parts that might come into
contact with the electrically powered components.
• Do not work underneath the raised machine without adequate fixed safety supports.
WARNING:
• Read all the relevant instructions carefully before performing any maintenance/repair
operations.
• If the machine does not work properly, check this is not caused by failure to carry out routine
maintenance. Otherwise, ask for the intervention of the authorised technical assistance centre.
• Restore all electrical connections after any maintenance interventions.
CAUTION:
• When carrying out maintenance switch off the machine using the main switch (then removing
the key from the block) and disconnect the power cable from the wall socket.
• Avoid contact with moving parts. Do not wear loose clothing or jewellery and tie up long hair.
• Block the wheels before lifting the machine.
• Lift the machine with equipment suitable for the weight to be lifted.
ATTENTION:
• Never tamper with the machine protection devices for any reason. Always follow the supplied
routine maintenance instructions scrupulously.
• If the machine needs to be pushed for maintenance purposes (batteries absent; discharged
batteries; etc.), never exceed 4 km/h.
8