Adapter Configuration Menu - LSI LSI8751SP User Manual

3.2.1.3 Additional Adapter Configuration
3.2.1.4 Display Mode
3.2.1.5 Mono/Color
3-6
To change an adapter's boot order, select it and press Enter. The system
prompts the user to enter the new boot sequence number. To remove an
adapter's boot order, press Enter again rather than entering a new
sequence number. While the maximum capacity is 32 adapters, only four
adapters can be assigned a boot order starting with boot sequence
number zero (0). If an invalid number is entered, an error message
appears. When the adapters are ordered as desired, press the Escape
(Esc) key to exit from this menu.
Additional Adapter Configuration allows the user to configure an adapter
that is not assigned a boot order. When this option is selected, the
Adapter Configuration menu (as shown in
Figure 3.4

Adapter Configuration Menu

Main Menu
BootSeq Bus DevFunc BootSeq
1 LSI53C825 00
LSI53C895
Highlight the adapter to be configured and press Enter. The message
Resetting Adapter, Please wait appears, and then the system scans
for devices. Finally, the Utilities menu appears and lists the available
options, which are described below.
Display Mode determines how much information about the host adapters
and SCSI devices appear on your computer monitor during boot. For
more complete information, choose the verbose setting. For a faster
boot, choose the terse setting.
Mono/Color allows the user to choose between a monochrome or color
display for the SCSI BIOS Configuration Utility. If needed, choose the
mono setting to get a more readable screen on a monochrome monitor.
Configuring the LSI8751SP
A0 0
Figure 3.4) appears:
Bus DevFunc
LSI53C875 00 98