Related Manuals for LSI SAS 9201-16i
Summary of Contents for LSI SAS 9201-16i
-
Page 1: Host Bus Adapter
LSI® SAS 9201-16i PCI Express® to 6Gb/s Serial Attached SCSI (SAS) Host Bus Adapter User Guide Version 1.0 August 2011 DB15-000855-00... -
Page 2: Revision History
LSI Corporation reserves the right to make changes to the product(s) or information disclosed herein at any time without notice. LSI Corporation does not assume any responsibility or liability arising out of the application or use of any product or service described herein, except as expressly agreed to in writing by LSI Corporation; nor does the purchase, lease, or use of a product or service from LSI Corporation convey a license under any patent rights, copyrights, trademark rights, or any other of the intellectual property rights of LSI Corporation or of third parties. -
Page 3: Table Of Contents
LSI SAS 9201-16i PCI Express to 6Gb/s SAS HBA User Guide Table of Contents August 2011 Table of Contents LSI SAS 9201-16i PCI Express to 6Gb/s SAS HBA User Guide............... . 4 1 Overview . -
Page 4: Lsi Sas 9201-16I Pci Express To 6Gb/S Sas Hba User Guide
The LSI SAS 9201-16i HBA is based on the Fusion-MPT™-architected LSI SAS 2116 controller that integrates the latest enhancements in PCIe 2.0 technology and 6Gb/s SAS technology. The LSI SAS 9201-16i HBA has onboard Flash memory for the firmware and BIOS. The LSI SAS 9201-16i HBA also includes onboard DDR-2 SDRAM. -
Page 5: Sata + Sas
LSI SAS 9201-16i HBA Characteristics Flash The LSI SAS 9201-16i HBA has onboard Flash ROM for the firmware and BIOS. The LSI SAS 9201-16i HBA provides one 4 M x 16-bit Flash ROM for storing the firmware and the BIOS. -
Page 6: Connectors
PCIe Connector (EC1). The LSI SAS 9201-16i HBA supports a x8 interface. The PCIe connection is through the edge connector, EC1, which provides connections on both the top (EC1B) and bottom (EC1A) of the board. The signal definitions and pin numbers conform to the PCIe specification. -
Page 7: Physical Characteristics
Physical Characteristics The LSI SAS 9201-16i HBA is a 6.6-in. x 4.2-in. board. The component height on the top and bottom of the LSI SAS 9201-16i HBA is in accordance with the PCIe specification. The following figure shows the board connectors. -
Page 8: Thermal And Atmospheric Characteristics
Safety Characteristics All LSI SAS 9201-16i HBAs meet or exceed the requirements of UL flammability rating 94V-0. Each bare board is marked with the supplier’s name or trademark, type, and UL flammability rating. Because these boards are installed in a PCIe bus slot, all voltages are less than the SELV 42.4-V limit. - Page 9 Align the HBA to the PCIe slot. Press down gently, but firmly, to properly seat the HBA in the slot. The following figure shows how to insert the HBA in a PCIe slot. Figure 2 Installing an LSI SAS 9201-16i HBA in a PCI Express Slot Bracket...