Quick Host Adapter Installation - LSI 320 User Manual

1.2 Quick Host Adapter Installation

1-2
To utilize Ultra320 SCSI performance, you must connect only Low
Voltage Differential (LVD) devices to the host adapter. If you connect
single-ended (SE) devices and LVD devices, the entire bus will drop to
the lower SE speed, limiting bus performance to Ultra SCSI.
The Ultra320 SCSI host adapters support all major operating systems,
such as Windows (NT 4.0, 2000, NET and XP), Linux, NetWare,
UnixWare, SCO OpenServer 5.X, OS/2, and Solaris. Other software
support includes SureLINK™ Domain Validation on Windows systems.
Domain Validation ensures data integrity by intelligently testing the
network before completing negotiation.
The Ultra320 SCSI host adapters utilize Fusion-MPT™ architecture for
all major operating systems, which allows for thinner drivers and better
performance. To obtain a device driver that supports your operating
system, contact the LSI Logic technical support team at 719-533-7230
or visit our website at http://www.lsilogic.com.
Use these quick installation steps if you have installed computer add-in
boards before and connected devices to them. If you prefer more
detailed instructions and guidance, refer to
Ultra320 SCSI Host Adapter," page
To install an Ultra320 SCSI to PCI-X Host Adapter board, follow these
steps:
Step 1. Turn off and unplug the computer.
Warning: Be sure to disconnect the computer's power before you
remove the cover and install the Ultra320 SCSI host
adapter.
Step 2. Open your computer cabinet by removing its cover.
Step 3. Be sure to touch a grounded metal surface to discharge static
electricity before handling the host adapter.
Step 4. Remove the host adapter board from its packaging and
examine it for any damage.
Step 5. Locate an unused PCI-X or PCI slot.
Quick Installation Procedures
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
Section 2.1, "Installing your
2-1.