GEIGER SOLIDline GU4506 Original Assembly And Operating Instructions page 8

Adjusting the Lower End Position
I
The lower end position must be adjusted
first.
From far range, press the up or down button and hold until
the awning has reached the desired end position.
Corrections are possible with the up and down buttons.
Saving the lower end position:
From close range, press the up or down button and hold
approx. 1 second, then release.
The motor responds (1 x 'Click-Click').
Adjusting the Upper End Position
From far range, press the up or down button and hold
approx. 3 seconds until the awning retracts and locks.
As soon as the casing is closed, the motor automatically
turns off and the upper end position is saved. You will hear
the motor (1 x 'Click-Click'). The up and down buttons are
now assigned to the corresponding turning direction of the
motors!
Programming is finished and the motor has changed
to normal operation.
I
Finally, conduct at least one trial run, so
EN
that the motor electronics can automa-
tically detect the threshold of the torque
disconnection.
I
Please note! When changing the end
position, the power level is reset to its
standard setting (Level 4).
8
EN
Gerhard Geiger GmbH & Co. KG | 100W0537
min.
1,5 m
click-
1 x
click
max.
15 cm
min.
1,5 m
click-
1 x
click
max.
15 cm
en V001 0718