Setting Up The Modem - Paradyne FrameSaver SLV Series Installation Instructions Manual

Setting Up the Modem

FrameSaver 9126 and 9128 units have an integral modem for remote management.
It is already set up for dial-in access to the unit, with Port Use set to Terminal.
If using the modem for dialed IP network connectivity
(SNMP, Telnet, FTP, or trap dial-out):
1. Select Modem Port.
Configuration
2. Minimally, change Port Use to Net Link, Save the change, and return to the
Management and Communication menu.
– Change Port Use to Net Link.
– Assign the IP Address and Subnet Mask if it is different from the Node.
– Change Link Protocol to SLIP, if necessary. The default setting is PPP.
3. Save the configuration and return to the Configuration Edit/Display menu.
See Setting Up the Internal Modem in Setup of the User's Guide for additional
information.
If trap dial-out is desired:
1. Set up the modem call directory phone numbers.
Main Menu
2. Select the desired Directory Number (A for Alarm, or 1– 5 for an alternate trap
destination if the A does not answer).
3. Enter the phone number(s). Use valid characters only:
– ASCII text
– B for blind dialing
– W for wait for dialtone
– P for pulse dialing unless B specified
– T for tone dialing unless B specified
– Space, underscore ( _ ), comma ( , ) for a 2-second pause, and dash (–)
readability characters
4. Save the phone number(s) and return to the Configuration Edit/Display menu.
5. Select SNMP Traps.
Configuration
– Enable SNMP Traps.
– Assign SNMP Trap Managers.
– Specify the IP address of the NMS that traps will be sent to when dialing out.
– Select desired trap categories.
6. Save the configuration and return to the Management and Communication menu.
Management and Communication
Control Modem Call Directories
Management and Communication
12
Modem Port
SNMP Traps