Installing And Setting Up The Framesaver Slv - Paradyne FrameSaver SLV Series Installation Instructions Manual

Installing and Setting Up the FrameSaver SLV

To complete the installation, you must:
H
Configure the FrameSaver unit.
H
Connect to the network.
H
Configure SNMP Trap Managers.
H
Connect to the DSX, if applicable (FrameSaver 9124, 9126, or 9128 only).
H
Connect to the DTE.
H
Connect to the modem (FrameSaver 9126 or 9128 only).
H
Connect to the ISDN, if applicable (FrameSaver 9126 or 9128 only).
NOTE:
Follow these instructions as they are presented. Installation time will be increased
if you connect the cables first.
Verifying that Self-Test Passed
Before starting to configure the FrameSaver unit, confirm that the unit passed the
self-test.
1. Follow this menu selection sequence from the Main Menu, pressing Enter after
each selection:
Main Menu
2. Check the Self-Test Results column (in the center of the System and Test Status
screen).
– If Passed appears, the FrameSaver unit successfully completed the self-test.
– If any failure messages appear, reset the unit by disconnecting, then
reconnecting the power cord. The unit will perform the self-test again. If the
failure reappears, call your service representative for assistance.
Status System and Test Status
8