Checking Status Of Ft Server - NEC Express5800/R320g-E4 Installation Manual

Chapter 1 Installing Operating System
11. When the message below appears, enter "yes" to restart the system. The ESXi host restarts.
A host reboot is required to place these updates into service.
Enter 'yes' to reboot now or 'no' to allow a manual reboot later: [yes]
12. After making sure that the ESXi host is shutdown, take the ft control software Install DVD out from the
drive.

Checking status of ft server

1. After the ftSys Management Appliance restarts, check the duplication status. Confirm that the System
FT LED on the front of the server lights.
2. Run the following command to confirm if the system is running normally.
# /opt/ft/sbin/ft-verify
The results list for each of the configuration is output. If all items show [PASS], it indicates that the
installation has been completed successfully (Output example:).
ftSys Management Appliance hosted by xxx.xxx.xxx.xxx
Host is configured with enough memory
ftSys installed on host
Host software version matches expected version (x.x.x-xxx)
ftSys Management Appliance firewall settings
Host Firmware Boot Type - requires UEFI
Host Legacy memory copy BIOS setting
ftSys Management Appliance installed on boot volume
Multiple paths to storage
Network Configuration
Host ftSys service started
Host logs available after reboot
DNS Configuration
58
Note The version displayed in "Host software version matches expected version" above is
different from the version of the ft control software displayed in "2.2 Confirmation of the ft
control software Version" of this chapter.
Express5800/R320g-E4, R320g-M4 Installation Guide (VMware)
1. Setup Procedure
System FT LED
[PASS]
[PASS]
[PASS]
[PASS]
[PASS]
[PASS]
[PASS]
[PASS]
[PASS]
[PASS]
[PASS]
[PASS]
[PASS]