Setting Hba Configuration By Using Qlogic - NEC Express5800/R320g-E4 Installation Manual

Chapter 1 Installing Operating System
1.6

Setting HBA configuration by using Qlogic

Setting HBA configuration by using Qlogic. Setting is needed to HBA installed into each CPU/IO module 0 and
1.
1. Connect power cords in the following order to start the system from CPU/IO module 0.
(1) Connect a power cord to AC inlet A.
(2) Connect a power cord to AC inlet B.
(3) Make sure that POWER LED on each module is blinking green.
2. Press the POWER switch that is located on the front side of the server.
In the QLogic prompt window which appears during POST, press Ctrl+Q or Alt+Q to launch
2-1
Fast! UTIL.
Important Before setting the HBA configuration by using QLogic BIOS, it is required to complete
the storage settings such as creating a logical disk.

Note Wait at least 15 seconds after step (1), and then perform step (2).

If you disconnect a power cord, wait for at least 30 seconds before connecting it again.
See Chapter 1 (1.2 Preparations for Setup) for AC inlet connector.
Tips
Important Make sure that the PRIMARY LED on CPU/IO module 0 is lit.
Note If QLogic prompt is not indicates, check the "PCIx Slot Option ROM" and "Boot Mode"
setting. Refer to step 9 and step 10 in "1.4 Enabling Fibre Channel card".
Express5800/R320g-E4, R320g-M4 Installation Guide (VMware)
1. Setup Procedure
QLogic
25