Checking Status Of Ft Server - NEC Express 5800 Series Installation Manual

Hide thumbs Also See for Express 5800 Series:

Table of Contents

Chapter 1 Installing OS

10. When the message below appears, enter "yes" to restart the syst em. The ESXi host restarts.

A host reboot is required to place these updates into service.

Enter 'yes' to reboot now or 'no' to allow a manual reboot later: [yes]

11. After making sure that the ESXi host is shutdown, take the ft control software Install DVD out from the

drive.

1.11.3 Checking status of ft server

After the ftSys Management Appliance restarts, check the duplication status. Confirm that the System

FT LED on the front of the server lights.

Run the following command to confirm if the system is running normally.

# /opt/ft/sbin/ft-verify

The results list for each of the configuration is output. If all items show [PASS], it indicates that the

installation has been completed successfully.

Output example:

ftSys Management Appliance hosted by xxx.xxx.xxx.xxx

Host is configured with enough memory

ftSys installed on host

Host software version matches appliance (5.1.1-233)

ftSys Management Appliance firewall settings

ftSys Management Appliance installed on boot volume

Multiple paths to storage

Network Configuration

Host ftSys service started

Host logs available after reboot

DNS Configuration

Express5800/R320d-E4, R320d-M4 Installation Guide (VMware 5.5)

1. Setup Procedure

System FT LED

[PASS]

Table of Contents