Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Remove the drain assembly from the bath and install loosely to the trap.
Final drain connection to the bath will be made after the bath is set into the frame.
Place a clean drop cloth on the bottom of the basin area. This will prevent scratching the surface of the bath
during installation.
NOTICE: Tiling-in bead should be installed if the fi nished wall material will come into contact with any top
surface of the bath. The tiling-in bead prevents water from seeping behind the wall and allows for an alcove
installation of many drop-in baths when a flanged version is not available.
NOTICE: The bottom edge of the tiling-in bead may have to be trimmed. This will ensure a proper fi t in the
installation location.
Thoroughly clean the bath rim.
Install the tiling-in bead. Refer to the manufacturer's instructions for proper installation.
Level Sensor
For All Installations
Position a clean drop cloth or similar material in the bottom of the bath to protect the fi nish. Ensure that the
airjets are covered. Be careful not to scratch the surface of the bath.
Blower Motor and Check Valve Options
NOTE: This bath with airjets allows the blower motor and check valve to remain on the bath support board
(standard installation) as it is shipped or to be relocated in another location (remote installation). Refer to your
applicable installation, standard or remote, throughout this installation guide.
1107630-2-C
9 of 28
PREPARE THE SITE (CONT.)
2. INSTALL THE TILING-IN BEAD (OPTIONAL)
3. PREPARE THE BATH WITH AIRJETS
Airjet
60" x 32" Acrylic Air Bath
User Keypad
Bath
Blower Motor
Control
Questions? Problems? For additional assistance, please contact KALLISTA's Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
Advertisement
Table of Contents
