INSTALLATION INSTRUCTIONS
Standard Installation Sections
Secure the Bath to the Subfl oor - Standard
Install the Plumbing - Standard
Make Power Connections - Standard
Then go to the "Test Run the Bath with Airjets" section.
Remote Location Sections
Disconnect the Blower Motor and Check Valve - Remote
Secure the Bath to the Subfl oor - Remote
Mount the Blower Motor and Check Valve - Remote
Connect the Cable at the Blower - Remote
Install the Power Cord at the Control - Remote
Install the Plumbing - Remote
Make Power Connections - Remote
Then go to the "Test Run the Bath with Airjets" section.
Clear spaces for
support blocks.
Spread a 2" (51 mm) layer of
cement or mortar bed material.
CAUTION: Risk of product damage. Do not support the bath with airjets by the rim.
NOTICE: Do not lift the bath by the air harness or blower motor, or use the piping or blower motor for structural
support of the bath.
NOTICE: The bath must be secured using one of the following two methods: cement or mortar bed, or
construction adhesive.
NOTICE: Ensure the subfl oor is level before proceeding. If necessary, use shims to achieve level.
1107630-2-C
10 of 28
PREPARE THE BATH WITH AIRJETS (CONT.)
4. SECURE THE BATH TO THE SUBFLOOR - STANDARD
60" x 32" Acrylic Air Bath
Apply construction
adhesive to the
support blocks.
Questions? Problems? For additional assistance, please contact KALLISTA's Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.