Product Information; Electrical Requirements; Product Notices; Factory Assembled Features - Kallista P50047-G5 Installation Instructions Manual

INSTALLATION INSTRUCTIONS

Electrical Requirements

The installation must have a Class A Ground-Fault Circuit-Interrupter (GFCI) or Residual Current Device (RCD).
The GFCI or RCD protect against line-to-ground shock hazard. Use a 220-240 V, 15 A, 50/60 Hz dedicated
service for the bath with airjets.
For Canadian installations, install the bath with airjets in accordance with Canadian Electrical Code, Part I.

Product Notices

WARNING: Risk of personal or property damage. Unauthorized modifi cation may cause unsafe
operation or effect performance of the bath with airjets. Do not relocate the bath blower motor, or make
other modifi cations to the bath system in the absence of kit or other published instructions, as this could
adversely affect the performance and safe operation of the product. KALLISTA shall not be liable under its
warranty or otherwise for personal injury or damage caused by any such unauthorized modifi cation. Refer
to the "Before You Begin" section for blower motor relocation requirements, recommendations, and section
coverage information.
NOTICE: Keep the area around the blower motor clean and free of debris. Ensure that the area around the
blower motor is free of sawdust, insulation, dirt, or other small loose debris. Such material could clog the blower
motor air ducts and reduce the air fl ow through the blower.

Factory Assembled Features

Factory assembled components include a blower motor, air harness, control, check valve, butterfl y valves, lights
(if provided), electrical harnesses, and an illuminated user keypad. Other than power wiring and plumbing, no
assembly is required.

Connections and Service Access

NOTICE: Provide unrestricted service access to the blower motor. You must provide access for servicing
the blower motor and controls. The access must be located immediately next to the blower motor. Study the
"Rough-In Information" section of this publication.
Before installation, ensure that there is proper access to the blower motor and fi nal connections. If the blower
motor is installed in an enclosed area, an access panel is required at the blower motor. This panel should be at
least 34" (864 mm) wide and 15" (381 mm) high.
1107630-2-C
3 of 28

PRODUCT INFORMATION

Questions? Problems? For additional assistance, please contact KALLISTA's Customer
60" x 32" Acrylic Air Bath
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.