INSTALLATION INSTRUCTIONS
Cement or Mortar Bed Method
NOTICE: Do not use gypsum cement or drywall compound, as these materials will not provide a durable bond.
Only use cement or mortar.
Spread a 2" (51 mm) thick layer of cement or mortar on the subfl oor except where the support blocks will
be located.
Clear any cement or mortar away from the support block locations.
Place a plastic liner or similar material over the cement or mortar.
With help, carefully move the bath into the installation area. Make sure the blower motor control and
support blocks do not rest in the bed material.
Verify the support blocks are resting directly on the subfl oor. Reposition or shim as needed.
Verify the bath is level across the top. If the bath is not level, shims must be used under the support blocks.
Remove the protective tape from the rim.
Apply a continuous bead of silicone sealant around the entire rim of the bath. Allow the sealant to cure
according to the manufacturer's instructions.
Construction Adhesive Method
Apply a generous amount of high-quality construction adhesive to the bottom of the support blocks.
With help, carefully move the bath into the installation area.
Verify the support blocks are resting directly on the subfl oor. Reposition or shim as needed.
Verify the bath is level across the top. If the bath is not level, shims must be used under the support blocks.
Remove the protective tape from the rim.
Apply a continuous bead of silicone sealant around the entire rim of the bath. Allow the sealant to cure
according to the manufacturer's instructions.
CAUTION: Risk of property damage. A watertight seal must exist on all bath drain connections. The
watertight seal will prevent property damage.
NOTE: To simplify future maintenance, provide access to all plumbing connections.
Loosely make connections between the bath and overfl ow and the drain to the bath. Confi rm locations and
adjust as needed.
Tighten connections between the bath and overfl ow, drain to bath, and drain assembly to trap according to
the drain manufacturer's instructions.
Confi rm drain assembly connections are snug according to the drain manufacturer's instructions.
Install the faucet valving according to the faucet manufacturer's instructions. Do not install the faucet trim at
this time.
Open the hot and cold water supplies. Check all connections for leaks.
Fill the bath to the overflow. Check the drain connections for leaks. Repair as needed.
1107630-2-C
11 of 28
SECURE THE BATH TO THE SUBFLOOR - STANDARD (CONT.)
5. INSTALL THE PLUMBING - STANDARD
60" x 32" Acrylic Air Bath
Questions? Problems? For additional assistance, please contact KALLISTA's Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.