Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Activates Mode Selected
Rotate outer ring to
access desired mode.
Power On/Off - Turns the blower motor on and off. Symbols illuminated in blue indicate available modes/
features. Modes which are operating will display in green.
Activate Button - Press "OK" to activate the desired mode. The active mode will fl ash (green).
Up Arrow - Increases the air fl ow when the air fl ow mode is active. Increases the pulse speed when the
surge mode is active.
Down Arrow - Decreases the air fl ow when the air fl ow mode is active. Decreases the pulse speed when
the surge mode is active.
Outer Ring - Rotate the outer ring to the desired mode. The selected mode will fl ash (blue).
Indicator Bar - Shows the air fl ow volume when operating in the air fl ow mode. Shows the surge speed
when operating in the surge mode.
Purge Mode - Select to initiate the purge mode manually. The purge cycle will not start if there is water in
the bath. The purge mode blows any residual water out of the air channels. The blower motor starts and
runs at a low speed for about two minutes. An automatic purge cycle occurs when the bath is drained and
the water level falls below the level sensors.
Air Flow Mode - In this mode, air fl ow is directed through any combination of the airjets in the selected
zones. Air fl ow can be adjusted with the arrow buttons. When the surge mode is selected, the air fl ow mode
stops. When the air fl ow mode is selected while operating in the surge mode, the surge mode stops.
Zone 1 - This mode is used to select or deselect the air fl ow through Zone 1.
Zone 2 - This mode is used to select or deselect the air fl ow through Zone 2.
Zone 3 - This mode is used to select or deselect the air fl ow through Zone 3.
Surge Mode - When active, the air fl ow ramps up from minimum to maximum and then down again to
minimum. The surge speed can be adjusted between 10 seconds and 60 seconds by using the up or down
buttons. Zones can be selected or deselected when in the surge mode.
User Keypad "Sleep" Modes - To enhance your bathing experience, the keypad is programmed to
darken after approximately 15 seconds of inactivity. Only the last feature selected will remain illuminated.
To resume normal operation, press any key or turn the outer ring. Approximately 60 seconds after all
equipment is turned off, the keypad will darken completely to conserve power. Press the power button or
turn the outer ring to reactivate the keypad.
1107630-2-C
22 of 28
17. CONFIRM PROPER OPERATION
Zone 1
Air Flow Mode
Power On/Off
Rotating Ring Key Pad
60" x 32" Acrylic Air Bath
Zone 2
Zone 3
Surge Mode
Increase Flow or Surge
Decrease Flow or Surge
Indicator Bar
Purge Mode
Questions? Problems? For additional assistance, please contact KALLISTA's Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
Advertisement
Table of Contents
