Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Clear spaces for
support blocks.
Spread a 2" (51 mm) layer of
cement or mortar bed material.
CAUTION: Risk of product damage. Do not support the bath with airjets by the rim.
NOTICE: Do not lift the bath by the air harness or blower motor, or use the piping or blower motor for structural
support of the bath.
NOTICE: The bath must be secured using one of the following two methods: cement or mortar bed, or
construction adhesive. Choose the installation option that best applies to your particular installation. Follow the
appropriate instructions.
NOTICE: Ensure the subfl oor is level before proceeding. If necessary, use shims to achieve level.
Cement or Mortar Bed Method
NOTICE: Do not use gypsum cement or drywall compound, as these materials will not provide a durable bond.
Only use cement or mortar.
Spread a 2" (51 mm) thick layer of cement or mortar on the subfl oor except where the support blocks will
be located.
Clear any cement or mortar away from the support block locations.
Place a plastic liner or similar material over the cement or mortar.
With help, carefully move the bath into the installation area. Make sure the blower motor control and
support blocks do not rest in the bed material.
Verify the support blocks are resting directly on the subfl oor. Reposition or shim as needed.
Verify the bath is level across the top. If the bath is not level, shims must be used under the support blocks.
Remove the protective tape from the rim.
Apply a continuous bead of silicone sealant around the entire rim of the bath. Allow the sealant to cure
according to the manufacturer's instructions.
1107630-2-C
14 of 28
8. SECURE THE BATH TO THE SUBFLOOR - REMOTE
60" x 32" Acrylic Air Bath
Apply construction
adhesive to the
support blocks.
Questions? Problems? For additional assistance, please contact KALLISTA's Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
Advertisement
Table of Contents
