Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
7. DISCONNECT THE BLOWER MOTOR AND CHECK VALVE - REMOTE
Retaining
Screw
Baseboard
NOTICE: This section applies only to installations in which the blower motor and check valve are being
relocated from the shipping position on the support board.
NOTICE: Do not cut the air harness (pipes) for this installation.
NOTICE: The check valve must be relocated with the blower motor.
Removing the Blower Motor
Disconnect the blower motor electrical plug from the control.
Remove any cable ties that support the blower motor cord.
Remove the retaining screw holding the air harness on the blower motor discharge. Do not discard the
screw at this time.
Remove the four blower motor mounting screws from the blower adapter baseboard. Keep these screws.
While restraining the tee with one hand, slide the blower motor away from the tee.
Remove the blower motor from the bath.
Remove the Check Valve
Remove the upper retaining screw at the check valve. Do not discard the screw at this time.
Remove the check valve and attached PVC elbow from the bath.
Prepare the Site for the Blower Motor and Check Valve
NOTE: Refer to the "Before You Begin" section for detailed requirements for the blower motor relocation.
Prepare the site where the blower motor will be installed. The site must be within 15' (4.6 m) of the bath.
As appropriate, install an access panel to service the blower motor.
As appropriate to the installation, prepare the routing paths for the PVC piping and the new blower motor
power cable. Follow all applicable building, fi re, plumbing, and electrical codes.
1107630-2-C
13 of 28
Mounting
Screws
Control
Blower Motor
Electrical Plug
60" x 32" Acrylic Air Bath
Elbow
Screw
Questions? Problems? For additional assistance, please contact KALLISTA's Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
Check
Valve
Advertisement
Table of Contents
