Test Run The Bath With Airjets - Kallista P50047-G5 Installation Instructions Manual

INSTALLATION INSTRUCTIONS
Air Flow Mode
Activates Mode Selected
Power On/Off
Rotate outer ring to
access desired mode.
For All Installations
NOTE: For additional information on bath with airjets operation, see the "Confi rm Proper Operation" section.
 Check all electrical connections, and make sure the electrical power to the bath is turned on.
 Make sure all PVC piping connections are properly made.
 Temporarily remove the protective drop cloth from the bath.
 Ensure that the area around the blower motor is clean and free of dust or debris.
 Fill the bath to a level at least 4" (102 mm) above the top of the highest airjet.
 Press the power button to start the bath.
 Operate the bath with air fl ow in all three zones.
 Check all bath PVC connections for leaks.
 Stop the blower.
 Check for any water leakage at the bath, the bath drain, and the air harness.
 Test other features as desired by rotating the outer ring on the keypad and pressing "OK."
 Drain the bath and observe that the purge cycle starts.
 Allow the automatic purge cycle to complete.
 Replace the protective drop cloth in the bath.
 Turn off power to the unit.
1107630-2-C
20 of 28

14. TEST RUN THE BATH WITH AIRJETS

Zone 1
Rotating Ring Key Pad
60" x 32" Acrylic Air Bath
Zone 2
Zone 3
Surge Mode
Increase Flow or Surge
Decrease Flow or Surge
Indicator Bar
Purge Mode
Questions? Problems? For additional assistance, please contact KALLISTA's Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.