Table of Contents
Advertisement
plug for RS232 and
analogue output
(front view)
plug for 100-240V
metal housing
(front view)
plug for 100-240V
polycarbonate housing
(front view)
1. Current / voltage output:
2. RS232:
3. Display:
4. Push-Buttons for calibration purposes:
5. Diagnosis LEDs:
4.5
Connection configuration of bottom part of the housing
with integrated power supply / 100...240V AC (option V01)
4
3
5
1
2
Euro-Standard
External diameter of supply cable: 10-12mm
Maximum wire cross section: 1,5mm² (AWG 16)
The protection of the supply cable against excess current and
short-circuit shall be in accordance with national and local codes.
Bottom and centrepiece of the housing shall be grounded!
5.
OPERATING COMPONENTS
5.1
Circuit board
After removal of the housing cover, the following operating components on the circuit
board may be accessed for adaptation of the transmitter to the desired configuration.
1. Current / voltage output
2. RS232
If the device is switched from current to voltage output using the
configuration software the two jumpers must be located as follows:
for current signals:
for voltage signals:
Serial interface for configuration of the EE36.
pin connector for optional display.
see Hardware, chapter 7 "Humidity/Temperature calibration"
see Harware, chapter 7 "Humidity/Temperature calibration,"
and Hardware, chapter 8.3 "Self diagnosis and error messages"
Description:
RxD / B-
TxD / A+
GND
OUT1
OUT2
Description:
grounding
phase (L1)
neutral wire (N)
Description:
phase (L1)
neutral wire (N)
U
I
D1
S1
OUT2
OUT1
I
U
OUT2
OUT1
I
U
9
Connection assignment:
5
4
3
2
1
Connection assignment:
PE
1
3
Connection assignment:
1
3
(0.39-0.47")
3. Display
D2
S2
4. Push-button
5. Diagnosis LEDs
Hardware
Advertisement
Table of Contents
