Table of Contents
Advertisement
5.2
1. MEASURAND
SI
T
aw
x
4. MIN / MAX FUNCTION:
Transmitters of the EE36 series can display the highest and lowest measured value measured
since the last reset.
Highest measured value:
1. Select the desired measurand.
2. To display the maximum value of the selected measurand, press the ∆ button for at
3.1.To reset the instrument to its normal operating status, press the ∆ button once again
3.2.If both buttons are pressed for at least five seconds while the maximum value is
Lowest measured value:
1. Select the desired measurand.
2. To display the minimum value of the selected quantity, press the ∇ button for at least
3.1.To reset the instrument to its normal operating status, press the ∇ button once again
3.2.If both buttons are pressed for at least five seconds while the minimum value is
5. MEASURED VALUES:
The dominant value of the appropriate quantity is displayed in this field. For the factory
configuration, the measured values may fall between the measurement ranges shown below.
Water activity
Temperature
Water content
The measurement ranges indicated above can be set to individual requirements using the
configuration software (see software manual; chapter 5 "Index - Index Cards").
6. STATUS LINE:
- MIN; MAX: see point "MIN/MAX Function"
- CALIB LOW; CALIB HIGH: indicates the low or high humidity/temperature calibration point.
- REL1 / REL2: Status Relay
- "ERROR 01....04": see Hardware, chapter
Hardware
Display module / Option
REL1
aw: 0.38
:
Temperature
Water activity
Water content
least five seconds.
for five seconds.
displayed → the "MAX" symbol disappears → the maximum value will be deleted
(Reset).
five seconds.
for five seconds.
displayed → the "MIN" symbol disappears → the minimum value will be deleted (Reset).
aw
T
x
1. Measurand
2. Units
3. Measurand selection and
4. Min/Max function
5. Measured values
6. Status line
:
2. UNITS
SI
US
°C
°F
ppm
ppm
from
up to
0
1
-40
180
(-40°F)
(356°F)
0
1000
8.3 "Self-diagnosis and error messages
10
3. MEASURAND SELECTION:
Press the ∆ or ∇ button to
select the desired
measurand
unit
°C
(°F)
ppm
"
Advertisement
Table of Contents
