Table of Contents
Advertisement
Disclaimer
The manufacturer or his authorized agent can be only be held liable in case of willful or gross
negligence. In any case, the scope of liability is limited to the corresponding amount of the order
issued to the manufacturer. The manufacturer assumes no liability for damages incurred due to
failure to comply with the applicable regulations, operating instructions or the operating condi-
tions. Consequential damages are excluded from the liability.
1.3
Environmental aspects
Products from E+E Elektronik® are developed and manufactured observing of all relevant requirements
with respect to environment protection. Please observe local regulations for the device disposal.
For disposal, the individual components of the device must be separated according to local recycling
regulations. The electronics shall be disposed of correctly as electronics waste.
2
Product Description
The innovative, modular EE220 humidity (RH) and temperature (T) transmitter consists of a basic
unit and various pluggable, interchangeable probes.
The basic unit can accommodate one combined EE07 RH and T probe or two separate EE07
probes, one for RH and one for T. The EE07 probes are available in plastic or in stainless steel
enclosure, and can be plugged onto the basic unit either directly or with M12 extension cables up
to 10 m (32.8 ft) long. An optional kit facilitates the mounting of the probes into duct.
The EE220 basic unit is available with polycarbonate or with metal enclosure, suitable for wall
mount or for installation on rails (DIN EN 50022). For pharma and food industry the basic unit
features a rear cable inlet.
The measured values are available on two analogue voltage or current (2 wire, 4 – 20 mA) out-
puts, as well as on the optional display.
One or two point adjustment for RH and T of the transmitter can be easily performed with push
buttons on the electronics board of the EE220 basic unit. Alternatively, the EE07 probes can be
adjusted individually with the EE-PCA Product Configuration Adapter (see EE07 data sheet).
For surface moisture monitoring or for the early detection of condensation danger, EE220 can
accommodate the EE03 RH & T module (see data sheet EE03).
3
Scope of Supply
EE220 Basic Unit (does not include probes or probe cables; these are to be ordered separately)
• EE220 lt. according to ordering guide
• Cable gland M16 x 1.5
• Test report according according to DIN EN10204 - 3.1
• Operating Instructions
Probe (EE03 or EE07)
• EE03 or EE07 according to ordering guide
• Test report according according to DIN EN10204 - 3.1 (only EE07)
Probe cable for EE03 or EE07
• Probe cable according to ordering guide
Operating instructions for EE220 humidity / temperature transmitter
5
Advertisement
Table of Contents
