Table of Contents
Advertisement
1.
The manual is a part of the scope of supply and serves to ensure proper handling and optimum
functioning of the instrument. For this reason, the manual must be read before start-up.
In addition, the manual is for all personnel who require knowledge concerning transport, setup,
operation, maintenance and repair.
The manual must not be used for the purpose of competition without a written consent from
E+E Elektronik
Copies for personal use are permitted.
All information, technical data and illustrations contained in these instructions are based on
information available at the time of publication.
1.1
This symbol indicates a safety instruction.
These safety instructions should always be followed carefully.
By not following these instructions injuries of persons or material damage could happen.
Therefore E+E Elektronik
This symbol indicates a note.
These notes should be observed to achieve optimum functioning of the equipment.
1.2
•
•
•
•
•
•
•
•
•
•
1.3
Equipment from E+E Elektronik
environmental issues. When you dispose the equipment you should avoid environmental pollution.
For disposal of the transmitter the individual components must be sorted with care. The housing
consists of recyclable polycarbonate or metal (aluminium, Al Si 9 Cu 3). The electronics must be
collected as electronic scrap and disposed of according to the regulations in force.
Hardware
GENERAL
®
and must also not be forwarded to third parties.
Symbol assertion
®
does not accept liability.
Safety instructions
General Safety Instructions
Excessive mechanical loads and incorrect usage should always be avoided.
Take care when unscrewing the filter cap as the sensor element could be damaged.
The sensor is an Electro Static Discharge sensitive component (ESD). When
touching the sensor element, ESD protective measures should be followed.
Grip sensors only at the lead wires.
Installation, electrical connection, maintenance and commissioning should be
performed by qualified personnel only.
Safety instructions for use of the alarm module with voltages >50V
To insulate the optional alarm module from the low-voltage side of the transmitter, the
partition provided for this purpose must be fitted in the lower section.
During operation of the instrument the modular housing must be completely closed.
The protection class of an opened housing corresponds to IP00 and direct contact
with components carrying dangerous voltages is therefore possible. In general, work
on live components should be avoided and when absolutely necessary, should be
performed by qualified personnel only.
Safety instructions for use of the integrated power supply (option V01)
During operation of the instrument the modular housing must be completely closed.
The protection class of an opened housing corresponds to IP00. In general, work
on live components should be avoided and when absolutely necessary, should be
performed by qualified personnel only.
Environmental aspects
®
is developed with due consideration to all resultant
4
Advertisement
Table of Contents
