Advertisement
11. Securely insert connector PJ1 on the PWB-
EFI board (5) into the connector on the con-
troller board Assy.
C4342U229AA
12. Use the three screws removed in step 9 to
secure the PWB-EFI board.
C4342U230AA
Image Controller IC-401 (Interface Kit VI-501)
14. Install the shield cover. (12 screws)
15. Install the right rear cover. (4 screws)
16. Install the upper rear cover. (5 screws)
17. Install the lower rear cover. (7 screws)
18. Connect the copier cable removed in step 7. (2 screws)
– 5 –
13. Install the controller board cover removed in
step 8. (9 screws)
During installation, also secure the PWB-
EFI board with the enclosed screws. (2
screws) (10)
C4342U231AA
Advertisement
