Advertisement
8.3
Common Settings for Controllers
(The recommended settings are underlined and the settings within [ ] are the default set-
tings.)
Server Setup
Server Name
Printer Setup
Publish Direct
Publish Print Queue
Publish Hold Queue
8.4
Specifying the Settings Necessary for Printing on a Net-
work
The following procedure describes how to specify the settings necessary for printing on a
network.
Follow the procedure described below to specify the settings necessary for printing on a
network.
1. Install the printer driver. At this time, specify the LPT1 port as the printer port.
■ Installing the Printer Driver
a. Start up the Add Printer Wizard, and then click [Next].
b. In the dialog where the printer connection can be selected, select [Local printer], and
then click [Next].
c. In the dialog where the manufacturer and model of the printer can be selected, click
[Have Disk].
d. Click [Browse], select the setting file from the corresponding folder on the CD-ROM,
and then click [OK].
e. Select the model of the printer from the printer list, and then click [Next].
f.
Select the LPT1 port, and then click [Next].
g. When [Next] is clicked, installation of the driver will begin.
h. Specify the printer name and whether the printer will be the default printer and
whether a test print will be printed.
NOTE
Do not print a test page yet.
Perform the test print after the network connection settings have been specified.
Image Controller IC-401 (Interface Kit VI-501)
Enter the server name.
Yes/No [Yes]
Yes/No [Yes]
Yes/No [Yes]
– 16 –
2. Follow the procedure below to specify the settings necessary for printing on a net-
work. Change the printer port from the one specified when the printer driver was
installed in step 1 to a port for a network connection, and then change any controller
settings as necessary.
NOTE
For IPP printing and NetWare printing, begin from the time when the printer driver was
added.
■ Network Printing on a Computer Running Windows
Procedure for connecting a network that can be selected for the various Windows operat-
ing systems
The procedure for specifying settings differs depending on the output procedure (LPR,
Windows printing or IPP).
Follow the appropriate connection procedure for the environment that you are using.
Windows
Windows NT
98/Me
4.0
LPR
2
SMB
IPP
Windows
Windows XP/
2000
Server 2003
2
2
2
2
2
2
2
2
Protocol
Used
TCP/IP
Advertisement
