C4342U225AA
* *
C4342U226AB
Image Controller IC-401 (Interface Kit VI-501)
7. Disconnect the copier cable. (2 screws)
8. Remove the controller board cover at the
right side of the copier. (Refer to the
descriptions below for details on the number
of screws.)
If the EK-501 local connection kit circuit
board is not installed: 9 screw
If the EK-501 local connection kit circuit
board is installed: 9 + 1 screws (marked
with "*")
C4342U227AA
C4342U228AA
– 4 –
9. Remove the three screws for the controller
board Assy.
10. Install the enclosed shoulder screws (6) at
the positions where screws were removed
in step 9. (3 screws)
NOTE
Be sure to use the enclosed shoulder screws
(part number 6 in the contents list).
Shoulder Screw (6)
C4342U240AA