Table of Contents
Advertisement
Error Check
Should error be found in this instrument, try corrective actions shown in the following
table. If this does not help, this instrument has possibly been broken. Please contact the
nearest Konica Minolta-authorized service facility with error number and version of your
instrument. Version can be identified in procedure on p.116.
Error
Symptom
No.
1
No display on LCD
screen even after power
is on.
2
Nothing is visible
through finder.
3
Does not accept key
operation.
4
Measurement unavail-
able even after pressing
measurement button
5
Gap between entered
value in calibration
value or target color
and that appearing after
setting
Item to Check
Has AC adapter been
properly plugged to AC
outlet?
Has AC adapter been
connected to this instru-
ment?
Is AC power source
within rated?
Have batteries been
placed?
Haven't batteries
drained?
Isn't lens cap on objec-
tive lens?
Hasn't ND filter covered
objective lens?
Hasn't ND filter covered
finder?
Hasn't remote mode
been set?
Don't you press unfunc-
tional key?
Hasn't it been KEY
LOCK?
Doesn't menu screen
appear?
113
Corrective Action
Connect AC adapter.
Connect AC adapter.
Use within +/-10% of the
nominal voltage.
Place batteries.
Replace with new batter-
ies or connect with AC
adapter.
Remove lens cap.
Do not use ND filter
except for the case when
object to measure is of
high luminance.
Do not use ND filter
except for the case when
object to measure is of
high luminance.
Press [ESC] key to can-
cel remote mode.
Press correct key.
Press [KEY LOCK] key
for approx. 2 or more
seconds to release KEY
LOCK.
Conduct measure-
ment with measurement
screen appearing.
Calculation error could
be found by 1 digit.
Page to
Refer
23
23
8
25
25
-
-
-
99
-
14
18
116
Advertisement
Table of Contents
