Error Messages - Konica Minolta CM-36dGV Instruction Manual

Error Messages

During control from the computer connected to the instrument using the optional SpectraMagic NX (CM-S100w)
color data software, error messages such as the following may be displayed on the SpectraMagic NX (CM-S100w)
operating screens.
When a message is displayed, perform the correction shown below. If the conditions do not return to normal after
performing the correction, contact a KONICA MINOLTA-authorized service facility.
Symptom Displayed message
Warning Because much time has
passed since calibration, it is
recommended that calibration
be performed again.
Regularly scheduled device
calibration is approaching.
Regularly scheduled device
calibration is required. Have
regularly scheduled device
calibration performed.
The reflectance is outside
the range of guaranteed
performance.
The gloss value is outside
the range of guaranteed
performance.
The reflectance and gloss
value are outside the range of
guaranteed performance.
The gloss value exceeded the
upper limit.
The light intensity of the
light source used for color
measurement has dropped.
The light intensity of the
light source used for gloss
measurement has dropped.
Possible cause
A certain amount of time
passed after white calibration.
The time when regularly
scheduled device calibration is
required has arrived.
A certain amount of time
passed after regularly
scheduled device calibration.
The reflectance of the
measured specimen was more
than 200%.
The gloss value of the
measured specimen was 200
to 400.
The reflectance of the
measured specimen was more
than 200%, and the gloss value
was 200 to 400.
Gloss measurement with that
specimen is not possible.
The light intensity of the
light source used for color
measurement has dropped.
The light intensity of the
light source used for gloss
measurement has dropped.
31
Correction
Perform white calibration
again.
For regularly scheduled device
calibration, contact a KONICA
MINOLTA-authorized service
facility.
For regularly scheduled device
calibration, contact a KONICA
MINOLTA-authorized service
facility.
—
—
—
To perform gloss
measurement, measure using
a different specimen.
To replace the color
measurement light source,
contact a KONICA MINOLTA-
authorized service facility.
To replace the gloss
measurement light source,
contact a KONICA MINOLTA-
authorized service facility.