X17 - X18; X19; X33; S1 - S2 - LinMot C1250 Series Installation Manual

Installation Guide C1250
8.6 X17 – X18
X17 – X18 RealTime Ethernet 10/100 Mbit/s
X17 RT ETH In
X18 RT ETH Out
RJ-45

8.7 X19

X19 System
RJ-45 Use isolated USB-RS232 converter (Art.-No. 0150-2473) for configuration over RS232

8.8 X33

X33
Spring cage connector (has
to be ordered separately:
see chapter 15)
8.9 S1 – S2
S1 – S2 Address Selectors
S1 (5..8)
S2 (1..4)
The use of these switches depends on the type of fieldbus which is used. Please see the corresponding manual for
further information.
NTI AG / LinMot
Specification depends on RT Bus. Please refer to according documentation.
1 (Do not connect)
2 (Do not connect)
3 RS232 Rx
4 GND
5 GND
6 RS232 Tx
7 (Do not connect)
8 (Do not connect)
case Shield
Safety Relays (only with the -1S option)
4 / 8 Ksr +
3 / 7 Ksr -
2 / 6 Ksr f+
1 / 5 Ksr f-
- Use 60/75°C copper conductors only
- Conductor cross-section max. 1.5mm
- Stripping length: 10mm
- The state of the feedback contacts has to be checked after each change of the state of the control
contacts!
- Never connect the safety relays to the logic supply of the drive!
→ For detailed information see chapter 10 Safety Wiring.
Bus ID High (0 ... F). Bit 5 is the LSB, bit 8 the MSB.
Bus ID Low (0 ... F). Bit 1 is the LSB, bit 4 the MSB.
Setting the ID high & low to 0xFF resets the drive to manufacturer settings!
0185-1063-E_6V16_IG_Drives_C1250
Safety Relay 1 / 2 Input positive
Safety Relay 1 / 2 Input negative
Safety Relay 1 / 2 feedback positive
Safety Relay 1 / 2 feedback negative
2
Page 13 of 32