Physical Dimension - LinMot C1250 Series Installation Manual

11 Physical Dimension

C1250 Series single axis drive
Width
Height
Height with fixings
Depth
Weight
Mounting Screws
Mounting Distance
Case, Degree of Protection
Storage Temperature
Transport Temperature
Operating Temperature
Relative humidity
Pollution
Shock resistance (16ms)
Vibration resistance (10-200Hz)
Max. Case Temperature
Max. Power Dissipation
Mounting place
Mounting position
Distance between Drives
* The derating is depending on the situation in the cabinet. The temperature of the drive should be checked under full load (the temperature
should be stable, which may take an hour or more). This allows to verify that enough margin is there if the cabinet goes to the maximum
allowable temperature of 40° C. For example, if the drive temperature reaches 45° C and the cabinet temperature is 30° C, this would result
in a drive temperature of about 55° C at a cabinet temperature of 40° C. The warning level of the drive is configured by default to 75° C and
the error level to 80° C. In this example, everything is fine. If the drive temperature is long time above the warning level, this might result in a
reduced lifetime of the drive.
Page 18 of 32
mm (in)
mm (in)
mm (in)
mm (in)
g (lb)
mm (in)
IP
°C
°C
°C
IEC/EN 60664-1
-1S option
-1S option
°C
W
mm (in)
0185-1063-E_6V16_IG_Drives_C1250
Installation Guide C1250
C1250-xx-XC-0S
25.3 (1.0)
166 (6.54)
206 (8.11)
106 (4.2)
630 (1.4)
2 x M5
188 (7.40)
20
-25...40
-25...70
0...40 at rated data (40...50 with power derating *)
< 95% (non-condensing)
Pollution degree 2
70
30
In the control cabinet
Vertical
Without Power Derating *:
20 (0.8) horizontal / 50 (2) vertical
With Power Derating *:
5 (0.2) horizontal / 20 (0.8) vertical
C1250-xx-XC-1S
176 (6.93)
216 (8.50)
700 (1.54)
2 x M5
198 (7.80)
3.5g
1g
NTI AG / LinMot