Ports & Devices; Maintenance; Support - Axis A1601 User Manual

AXIS A1601 Network Door Controller
System options
Bonjour
The Axis product includes support for Bonjour. Bonjour is enabled by default and the product is automatically detected by operating
systems and clients that support this protocol.
Bonjour can be disabled under Setup > Additional Controller Configuration > System Options > Network > Bonjour.
Ports & Devices
I/O ports
The auxiliary connector provides four configurable input and output ports for connection of external devices.
The external connector provides two configurable input and output ports for connection of external devices.
You can configure the I/O ports under Setup > Additional Controller Configuration > System Options > Ports & Devices > I/O
Ports. Select the port direction (Input or Output). You can give the ports descriptive names and their Normal states can be
configured as Open circuit or Grounded circuit.
Port Status
The list on the System Options > Ports & Devices > Port Status page shows the status of the product's input and output ports.

Maintenance

The Axis product provides several maintenance functions. These are available under Setup > Additional Controller Configuration
> System Options > Maintenance.
Click Restart to perform a correct restart if the Axis product is not behaving as expected. This will not affect any of the current
settings.
Note
A restart clears all entries in the Server Report.
Click Restore to reset most settings to the factory default values. The following settings are not affected:
• the boot protocol (DHCP or static)
• the static IP address
• the default router
• the subnet mask
• the system time
• the IEEE 802.1X settings
Click Default to reset all settings, including the IP address, to the factory default values. This button should be used with caution. The
Axis product can also be reset to factory default using the control button, see Reset to factory default settings on page 33.
For information about firmware upgrade, see How to upgrade the firmware on page 33.

Support

Support Overview
The Setup > Additional Controller Configuration > System Options > Support > Support Overview page provides information on
troubleshooting and contact information, should you require technical assistance.
31