Maintenance Instructions - Axis A1601 User Manual

AXIS A1601 Network Door Controller
System configuration
How to re-configure SmartIntego
1. Click Setup in the top menu.
2. Click Configure Services > Settings.
3. Click Re-configure.
4. Click Browse..., select the csv-file and click Upload file.
5. Select a GatewayNode and click Next.
6. A preview of the new configuration is shown. Disable the door monitors if needed.
Note
The door monitor settings come from the imported CSV file. You shouldn't need to change this setting in a normal installation.
7. Click Configure.
8. An overview of the doors included in the configuration is shown. Click Settings to configure each door individually.

Maintenance Instructions

To keep the access control system running smoothly, Axis recommends regular maintenance of the access control system, including
door controllers and connected devices.
Do maintenance at least once a year. The suggested maintenance procedure includes, but is not limited to, the following steps:
• Make sure all the connections between the door controller and the external devices are secure.
• Verify all the hardware connections. See Verification Controls Doors on page 16.
• Verify that the system, including the connected external devices, functions correctly.
- Swipe a card and test the readers, doors, and locks.
- If the system includes REX devices, sensors or other devices, test them as well.
- If activated, test the tampering alarms.
If the results from any of the steps above indicate faults or unexpected behavior:
- Test the signals of the wires using appropriate equipment and check if the wires or cables are damaged
in any way.
- Replace all damaged or faulty cables and wires.
- Once the cables and wires have been replaced, verify all the hardware connections again. See Verification
Controls Doors on page 16.
• If the door controller is not behaving as expected, see Troubleshooting on page 33 and Maintenance on page 31 for
more information.
20