Table of Contents
Advertisement
AXIS A1601 Network Door Controller
System configuration
The same options for date and time are also available in the System Options pages. Go to Setup > Additional Controller
Configuration > System Options > Date & Time.
Get the Date and Time from a Network Time Protocol (NTP) Server
1. Go to Setup > Date & Time.
2. Select your Timezone from the drop-down list.
3. If daylight saving time is used in your region, select Adjust for daylight saving .
4. Select Synchronize with NTP.
5. Select the default DHCP address or enter the address of a NTP server.
6. Click Save.
When synchronizing with an NTP server, date and time are updated continuously because the data is pushed from the NTP server. For
information about NTP settings, see NTP Configuration on page 28.
If you use a host name for the NTP server, a DNS server must be configured. See DNS Configuration on page 28.
Set the Date and Time Manually
1. Go to Setup > Date & Time.
2. If daylight saving time is used in your region, select Adjust for daylight saving .
3. Select Set date & time manually.
4. Enter the desired date and time.
5. Click Save.
When setting the date & time manually, date and time are set once and will not be updated automatically. This means that if the
date or time needs to be updated, the changes must be made manually because there is no connection to an external NTP server.
Get the Date and Time from the Computer
1. Go to Setup > Date & Time.
2. If daylight saving time is used in your region, select Adjust for daylight saving .
3. Select Set date & time manually.
4. Click Sync now and save.
When using the computer time, date and time are synchronized with the computer time once and will not be updated automatically.
This means that if you change the date or time on the computer you use to manage the system, you should synchronize again.
Configure the Network Settings
To configure the basic network settings, go to Setup > Network Settings or to Setup > Additional Controller Configuration >
System Options > Network > TCP/IP > Basic.
For more information about network settings, see Network on page 27.
Configure the hardware
You can connect readers, locks and other devices to the Axis product before you complete the hardware configuration. However,
it will be easier to connect devices if you complete the hardware configuration first. This is because a hardware pin chart will be
10
Hide quick links:
Advertisement
Table of Contents
