Inputs - ABB CoreSense M10 Installation Manual

Inputs

The 4–20 mA input range can be configured using the web interface.
WARNING
Shielded cable must be used for connecting to the 4–20 mA outputs.
—
Figure 43 Self-powered analog input wiring
Case
—
Figure 44 Loop-powered analog input wiring (two-wire - left, three-wire - right)
Case
NOTICE
For more information on the various communication cables used, see Table 4 on
page 24 and "Connector definitions" on page 89.
For more information on configuring the communication protocols, refer to the
CoreSense M10 Monitoring System User Guide.
Active
Case
Connecting the CoreSense M10
59