Powering Up The Coresense M10; Establishing Scada Connections - ABB CoreSense M10 Installation Manual

Powering up the CoreSense M10

NOTICE
NEVER try and start the system if the ambient temperature is below –40 °C (–40 °F).
Once all connections are properly set, you can power up the monitoring system.
To do so, simply close each breaker switch, as shown in Figure 40.
—
Figure 40 Pulling the breaker switches to power up the monitoring system

Establishing SCADA connections

ABB recommends using a Cat5 Ethernet cable.
NOTICE
Do not use the optical Ethernet port when using the copper-based SCADA Ethernet port.
56
Installation Guide