X 2.5-Inch Rear Drive Assembly - Huawei TaiShan 2280 V2 User Manual

TaiShan 2280 V2 Server
User Guide
Figure 5-23 Positions of drives
Step 9 Connect cables to the drive module. For details, see
Step 10 Install the chassis cover. For details, see
Step 11 Install the server. For details, see
Step 12 Connect the power cables. For details, see
Step 13 Power on the server. For details, see
Step 14 Log in to the iBMC WebUI, and check whether the new component is normal. For details, see
the
----End

5.10.2 4 x 2.5-inch Rear Drive Assembly

To install the rear drive module, perform the following steps:
Step 1 Wear an ESD wrist strap. For details, see
Step 2 Power off the server. For details, see
Step 3 Remove the power cables. For details, see
Step 4 Remove the server. For details, see
Step 5 Remove the chassis cover. For details, see
Step 6 Take the spare drive assembly out of its ESD bag.
Step 7 Install the rear drive assembly in the chassis and tighten the screws. See
Issue 01 (2019-07-01)
TaiShan Rack Server iBMC User
Copyright © Huawei Technologies Co., Ltd.
7 Internal
3.7 Installing the Chassis
4.4 Installing the Server on Guide
3.5 Connecting Cables to a
3.1 Powering On the
Guide.
12 Preventing Electrostatic
3.2 Powering Off the
3.4 Removing Cables from a
3.3 Removing the Server and Guide
3.6 Removing the Chassis
5 Optional Part Installation
Cabling.
Cover.
Rails.
PSU.
Server.
Discharge.
Server.
PSU.
Rails.
Cover.
Figure 5-24.
106