Rear Drive Module; X 3.5-Inch Rear Drive Assembly - Huawei TaiShan 2280 V2 User Manual

TaiShan 2280 V2 Server
User Guide
Figure 5-21 Installing a FlexIO
Step 8 Tighten the screw using the Phillips screwdriver to secure the FlexIO. See (2) in
Step 9 Install the server. For details, see
Step 10 Connect network cables to the FlexIO.
Step 11 Connect the power cables. For details, see
Step 12 Power on the server. For details, see
Step 13 Log in to the iBMC WebUI, and check whether the new component is normal. For details, see
the
----End

5.10 Rear Drive Module

5.10.1 2 x 3.5-inch Rear Drive Assembly

To install a rear drive module, perform the following steps:
Step 1 Wear an ESD wrist strap. For details, see
Step 2 Power off the server. For details, see
Step 3 Remove the power cables. For details, see
Issue 01 (2019-07-01)
NOTE
A tool is required for this operation.
TaiShan Rack Server iBMC User
Copyright © Huawei Technologies Co., Ltd.
4.4 Installing the Server on Guide
3.5 Connecting Cables to a
3.1 Powering On the
Guide.
12 Preventing Electrostatic
3.2 Powering Off the
3.4 Removing Cables from a
5 Optional Part Installation
Figure
Rails.
PSU.
Server.
Discharge.
Server.
PSU.
5-21.
104