Ac Psu - Huawei TaiShan 2280 V2 User Manual

TaiShan 2280 V2 Server
User Guide
Figure 5-6 Installing a drive
Step 6 Ensure that the ejector lever is fastened to the chassis beam, and then close it to completely
insert the drive into the chassis. See (2) in
Step 7 If the server is equipped with a front bezel, install the bezel after installing the front drive. For
details, see
Step 8 If you need to restore data on the newly installed drive, see Troubleshooting > Hard Drive
Fault of the corresponding RAID controller card in the
Card User Guide
Step 9 Log in to the iBMC WebUI, and check whether the new component is normal. For details, see
the
----End

5.4 AC PSU

To install an AC PSU, perform the following steps:
l PSUs on the same server must be of the same model.
l Use dedicated power cables to ensure equipment and personal safety.
l Power cables are used only for dedicated servers. Do not use them for other devices.
l Connect power cables of active and standby PSUs to different power distribution units
l Ground equipment before powering it on. Otherwise, high leakage current may cause
Step 1 Wear an ESD wrist strap. For details, see
Step 2 Remove the PSU filler. See
Issue 01 (2019-07-01)
5.2.2 Installing the Front
for detailed operations.
TaiShan Rack Server iBMC User
(PDUs) to ensure reliable system operating.
equipment damage.
Copyright © Huawei Technologies Co., Ltd.
Figure 5-6.
Bezel.
Guide.
12 Preventing Electrostatic
Figure 5-7.
5 Optional Part Installation
TaiShan Server RAID Controller
Discharge.
89