Screw-In Raid Controller Card - Huawei TaiShan 2280 V2 User Manual

TaiShan 2280 V2 Server
User Guide
Figure 5-10 Installing a PCIe card on a riser card
Step 11 Install the riser card tray. For details, see
Step 12 Install the chassis cover. For details, see
Step 13 Install the server. For details, see
Step 14 Connect the power cables. For details, see
Step 15 Power on the server. For details, see
Step 16 Log in to the iBMC WebUI, and check whether the new component is normal. For details, see
the
----End

5.6 Screw-in RAID Controller Card

To install the screw-in RAID controller card on the mainboard, perform the following steps:
Step 1 Wear an ESD wrist strap. For details, see
Step 2 Power off the server. For details, see
Step 3 Remove the power cables. For details, see
Step 4 Remove the server. For details, see
Step 5 Remove the chassis cover. For details, see
Step 6 If I/O module 2 is configured with a full-height full-length riser card tray, remove the riser
card tray above the RAID controller card. For details, see
Tray.
Step 7 If a supercapacitor is required, install it. For details, see
Step 8 Take a spare RAID controller card out of its ESD bag.
Step 9 Determine the position for installing the RAID controller card on the mainboard. See
5-11.
Issue 01 (2019-07-01)
TaiShan Rack Server iBMC User
Copyright © Huawei Technologies Co., Ltd.
3.13 Installing a Riser Card
3.7 Installing the Chassis
4.4 Installing the Server on Guide
3.5 Connecting Cables to a
3.1 Powering On the
Guide.
12 Preventing Electrostatic
3.2 Powering Off the
3.4 Removing Cables from a
3.3 Removing the Server and Guide
3.6 Removing the Chassis
5.7
5 Optional Part Installation
Tray.
Cover.
Rails.
PSU.
Server.
Discharge.
Server.
PSU.
Rails.
Cover.
3.12 Removing a Riser Card
Supercapacitor.
Figure
92