Mounting Flush Suspended Brackets - Screen Innovations 5 Motorized Owner's Manual

INSTALLATION - FLUSH

Mounting Flush Suspended Brackets

Install minimum 3/8'' threaded rod to structural members in the ceiling per the drawing
5b
below.
Parts to be supplied by installer
Threaded Rod 3/8'' Minimum
Stuctural Member
4" - 12"
(17.8 cm - 5
cm)
Ceiling
Z
Install the suspended ceiling bracket kits onto the case as shown below. Move the brackets to
match the horizontal position of the the threded rods and then lock down with all 4 screws in
each suspended ceiling bracket assembly.
12
FLUSH SUSPENDED
Nut Washer Washer Nut
4" - 12"
(17.8 cm - 5
cm)
INSTALLATION - FLUSH
Hang Case on Suspended Brackets and Raise Up
Raise the case up and guide the threaded rods through the holes in the suspended ceiling
6b
brackets. Secure with nuts and washers supplied by the installer
Use the nuts connected to the threaded rods to raise the case up untill the end flanges touch
the ceiling.
FLUSH SUSPENDED
Threaded
Rod
Supplied By
Nut
Installer
Washer
Washer
Nut
13