Motor Accessories - Screen Innovations 5 Motorized Owner's Manual

TROUBLESHOOTING
Problem Description Probably Cause
Indentations appear Debris or particles
on screen surface. adhering to screen due
to static cling.
Wrinkles near bottom Screen material has
of screen. stretched and thus
increased the tension on
the tabs.
Vertical wrinkles in Material has shifted at
screen the weight bar
RTS won't operate Remote too far away.
Remote orientation
RF interference
RF Shielding
Remote battery is dead
Antenna is not exposed.
Incorrect or poor cable
termination.
26
Action to Take
Check back of screen as well as front of screen for
dust or debris. Wipe the back of the screen with a
clean damp cloth. Also, lightly brush off the front
of the screen.
Follow the adjusting tab tension section
Gently move the material out to each end of the
weight bar until smooth.
Move to within 30 ft. of screen.
Hold remote vertical
Turn off other sources of RF
Move to position where metal objects, wiring, or
foliage does not block the signal.
Replace with CR2430 3V lithium button battery
Adjust the antenna location.
Check the wire pinouts and termination. Look for
broken, loose, or damaged wires. Determinate if
necessary.

MOTOR ACCESSORIES

Purchased Seperately
LinkPro Connect
Solo Remote
27