Front Panel Configuration - Rice Lake Revolution SURVIVOR 420HE Installation Manual

1.1.3

Front Panel Configuration

The 420 Plus indicator can be configured using a series of menus accessed through the indicator front panel when
the indicator is in setup mode. Table 1-1 summarizes the functions of each of the main menus.
Menu
CONFIG Configuration
FORMAT Format
CALIBR Calibration
SERIAL Serial
PROGRM Program
PFORMT Print Format
SETPNT Setpoint
DIG IN Digital Input
ALGOUT Analog Output
VERS Version
Four front panel keys are used as directional keys to navigate through the menus in setup mode (see Figure 1-2).
The ( ) and
UNITS PRINT
( ) move up and down (vertically) to different menu levels. The
GROSS/NET
for selecting parameter values within the menus. A label above each of these keys identifies the direction provided
by the key when navigating through the setup menus.
1 Level
st
Parameter
2 Level
nd
Parameter
Default value
When moving thr ough values below the first menu level, press
above. Press
14 420HE Installation Manual
Configure grads, zero tracking, zero range, motion band, overload, tare function, sample rate,
and digital filtering parameters.
Set format of primary and secondary units, display rate.
Calibrate indicator. See Section 1.0 on page 27 for calibration procedures.
Configure EDP and printer serial ports.
Set power-up mode, regulatory mode, and consecutive number values.
Set print format used for gross and net tickets. See Section 1.0 on page 35 for more
information.
Configure Setpoints and digital outputs.
Assign digital input functions.
Configure analog output module. Used only if analog output option is installed.
Display installed software version number.
420 Plus
Table 1-1.
Move UP/
Increrement
Move DOWN/
Value
Decrement
Value
Figure 1-2. Front Panel Key Functions in Setup Mode
( ) keys scroll left and right (horizontally) on the same menu level;
Value Value
or to move to the next parameter on the level above
Figure 1-3. Setup Mode Menu Navigation
Menu Function
Menu Summary
ENTER Move RIGHT/
value
Move LEFT/
Previous
TARE
Value
to r etur n to the level
Next
ZERO
key ( ) serves as an Enter key
1 Level
st
Parameter
2 Level
nd
Parameter
( ) and