Test Mode - Rice Lake Revolution SURVIVOR 420HE Installation Manual

1.9

Test Mode

Note Test mode is intended for factory use only.
In addition to normal and setup modes, test mode
provides a number of diagnostic functions for the 420
Plus, including:
• Display raw A/D count
• Reset configuration parameters to default
values
• A/D internal calibration
TEST
TEST Menu
Function
A/DTST Display A/D test
Press and hold Enter key to display raw count from A/D converter.
DEFLT Default parameters
Press setup switch and Enter key at the same time to reset configuration and calibration parameters to factory
default values. Load cells must be recalibrated before using the indicator (see Section 1.0 on page 27).
ADOFFS
A/DTST
Figure 1-6. Test Mode Menu
Exit Not Used
Figure 1-7. Front Panel Key Functions in Test Mode
Table 1-7. Test Mode Menu Functions
To enter test mode, press and hold the setup switch
until the front panel display shows the word
After about three seconds, the test mode display
automatically shifts to the first test menu function, A/
DTST.
Figure 1-6 shows the Test Menu structure; Figure 1-7
shows the front panel key functions in test mode. Note
that, because the Test Menu functions are all on a
single menu level, the
function. Press the
ZERO
Table 1-7 summarizes the test menu functions.
ADGAIN
ENTER Move LEFT Move RIGHT
Description
TEST
( ) key has no
GROSS/NET
( ) key to exit test mode.
DEFLT
.
47